Differences

This shows you the differences between two versions of the page.

--- wiki:cisco:cheatsheet [2023/02/23 07:14] – michel
+++ wiki:cisco:cheatsheet [2023/02/23 07:16] (current) – michel
@@ Line 3: / Line 3: @@
 **Cisco CLI Reference, Howtos, and Tools**
-## Full Navigation
-  * [Basic Networking](#basic-networking)
-    + [Setup](#setup)
-      - [Intialize](#intialize)
-      - [Basic Switch Config](#basic-switch-config)
-      - [Basic Router Config](#basic-router-config)
-      - [Basic Config with Password Security](#basic-config-with-password-security)
-      - [Basic Security](#basic-security)
-      - [Configure SSH](#configure-ssh)
-      - [Set Clock](#set-clock)
-      - [Basic Hardening (Work Needed)](#basic-hardening-work-needed)
-      - [Backup config over FTP](#backup-config-over-ftp)
-      - [Backup config over console](#backup-config-over-console)
-      - [Restore Config](#restore-config)
-      - [Nuking (ROMMON, Password Recovery, etc)](#nuking-rommon-password-recovery-etc)
-    + [Interfaces](#interfaces)
-      - [Interface Selection](#interface-selection)
-      - [Assign Static IP to Interface](#assign-static-ip-to-interface)
-      - [Interface Ranges](#interface-ranges)
-    + [Interface Verification](#interface-verification)
-      - [Remove IP Addresses](#remove-ip-addresses)
-    + [Console Port](#console-port)
-      - [Change Console Baudrate](#change-console-baudrate)
-    + [DHCP](#dhcp)
-      - [Snippet: Enable Router DHCP Server](#snippet-enable-router-dhcp-server)
-      - [Snippet: Enable Switch DHCP Server](#snippet-enable-switch-dhcp-server)
-      - [Create DHCP Pool](#create-dhcp-pool)
-      - [DHCP Verification](#dhcp-verification)
-      - [Disable DHCP](#disable-dhcp)
-      - [Re-enabled DHCP](#re-enabled-dhcp)
-      - [Create VLAN DHCP](#create-vlan-dhcp)
-      - [Verify DHCP Pool](#verify-dhcp-pool)
-      - [Delete DHCP Pool](#delete-dhcp-pool)
-  * [Intermediate Networking](#intermediate-networking)
-    + [VLANs](#vlans)
-      - [VLAN Creation](#vlan-creation)
-      - [Port Assignment](#port-assignment)
-      - [IP Assignemnt](#ip-assignemnt)
-      - [Verification](#verification)
-      - [Voice and Data VLAN](#voice-and-data-vlan)
-      - [Management VLAN](#management-vlan)
-      - [Delete VLANS on file](#delete-vlans-on-file)
-      - [Delete VLANS in memory](#delete-vlans-in-memory)
-      - [Inter-VLAN Routing](#inter-vlan-routing)
-    + [Trunks](#trunks)
-      - [Create multi-switch vlan trunk](#create-multi-switch-vlan-trunk)
-      - [Trunk Verification](#trunk-verification)
-    + [EtherChannel](#etherchannel)
-      - [Configure EtherChannel](#configure-etherchannel)
-      - [Verify EtherChannel](#verify-etherchannel)
-    + [DTP (Dynamic Trunking Protocol)](#dtp-dynamic-trunking-protocol)
-      - [Configure DTP](#configure-dtp)
-      - [Disable DTP](#disable-dtp)
-      - [Verify DTP](#verify-dtp)
-  * [Advanced Networking](#advanced-networking)
-    + [OSPFv2](#ospfv2)
-      - [OSPF Router IDs](#ospf-router-ids)
-        * [All Commands](#all-commands)
-        * [Enable router OSPF process](#enable-router-ospf-process)
-        * [Configure Loopback](#configure-loopback)
-        * [Configure OSPF Router ID](#configure-ospf-router-id)
-        * [Modify OSPF router ID](#modify-ospf-router-id)
-      - [OSPF - Point-to-Point Networks](#ospf---point-to-point-networks)
-        * [Network Command Syntax](#network-command-syntax)
-        * [Configure OSPF With Network Command](#configure-ospf-with-network-command)
-        * [Use Entire Gigabit Interfaces](#use-entire-gigabit-interfaces)
-        * [Configure OSPF with `ip ospf`](#configure-ospf-with-ip-ospf)
-        * [OSPF Passive Interfaces](#ospf-passive-interfaces)
-        * [Find Designated Router and Backup](#find-designated-router-and-backup)
-        * [Change OSPF from Broadcast to Point-to-Point](#change-ospf-from-broadcast-to-point-to-point)
-        * [Loopback and P2P Networks](#loopback-and-p2p-networks)
-      - [Multiaccess OSPF Networks](#multiaccess-ospf-networks)
-        * [Configure OSPF Priority](#configure-ospf-priority)
-      - [Modifying Single Area OSPF](#modifying-single-area-ospf)
-        * [Adjusting Reference Bandwidth](#adjusting-reference-bandwidth)
-        * [Manually Set OSPF Link Cost](#manually-set-ospf-link-cost)
-        * [Show OSPF Hello Packet Intervals](#show-ospf-hello-packet-intervals)
-        * [Set OSPF Hello Packet Intervals](#set-ospf-hello-packet-intervals)
-        * [Set OSPF Dead Interval](#set-ospf-dead-interval)
-      - [OSPF Default Routes](#ospf-default-routes)
-        * [Propogate Default Route](#propogate-default-route)
-        * [Verify Propogated Default Route](#verify-propogated-default-route)
-      - [Verify Single-Area OSPF](#verify-single-area-ospf)
-        * [Verify OSPF Neighbors](#verify-ospf-neighbors)
-        * [Verify OSPF Protocols](#verify-ospf-protocols)
-        * [Verify OSPF Process Info](#verify-ospf-process-info)
-        * [Verify OSPF Interface Setting](#verify-ospf-interface-setting)
-  * [How To's](#how-tos)
-    + [FTP Server Usage](#ftp-server-usage)
-    + [Install Packet Tracer on Fedora Workstation](#install-packet-tracer-on-fedora-workstation)
-    + [Console Access with `minicom` on Linux](#console-access-with-minicom-on-linux)
-    + [Configure Serial Port with `stty` on Linux](#configure-serial-port-with-stty-on-linux)
-  * [Tools](#tools)
-    + [Subnetting/Calcuation](#subnettingcalcuation)
-      - [ipcalc (*nix)](#ipcalc-nix)
-      - [sipcalc (*nix)](#sipcalc-nix)
-      - [whatmask (*nix)](#whatmask-nix)
 ## Basic Networking

User Tools

Site Tools

Differences

Page Tools